Ignition Switch - Toyota 2006 Sienna Owner's Manual

Ignition switch

"START"—Starter motor on. The key
will return to the "ON" position when
released.
For starting tips, see page 403 in Section
3.
"ON"—Engine on and all accessories
on.
This is the normal driving position.
"ACC"—Accessories such as the radio
operate, but the engine is off.
If you leave the key in the "ACC" or
"LOCK" position and open the driver's
door, a buzzer will remind you to remove
the key.
198
06 SIENNA_U (L/O 0603)
"LOCK"—Engine is off and the steering
wheel is locked. The key can be re-
moved only at this position.
You must push in the key to turn the key
from "ACC" to the "LOCK" position. The
selector lever must be put in the "P" posi-
tion before pushing the key.
Vehicles with engine immobilizer system—
Once you remove the key, the engine im-
mobilizer system is automatically set. (See
"Engine immobilizer system" on page 13
in Section 1- 2.)
When starting the engine, the key may
seem stuck at the "LOCK" position. To
free it, first be sure the key is pushed all
the way in, and then rock the steering
wheel slightly while turning the key gently.
It is not a malfunction if the needle on all
meters and gauges move slightly when the
key is turned to the "ACC", "ON" or
"START" position.
NOTICE
Do not leave the key in the "ON"
position if the engine is not running.
The battery will discharge and the
ignition could be damaged.
2006 SIENNA from March '06 Prod. (OM45443U)