Decorative Fronts - Heat & Glo 6000CLX-IPI-T Owner's Manual

FACTORY-INSTALLED NON-COMBUSTIBLE BOARD
A
inches
6000
millimeters
inches
8000
millimeters
Figure 13.4 Noncombustible Facing Diagram
C. Decorative Fronts
Only decorative fronts certified for use with this appliance
model may be used. Contact your dealer for a list of dec-
orative fronts that may be used. Once you have deter-
mined what kind of decorative front and finishing material
is going to be used on the fireplace, you may use the
table below which shows the decorative front models and
the finishing material thickness allowed.
DECORATIVE
FIT
FRONT
Folio Inside
Overlap
Arcadia
Inside
Overlap
Halston
Inside
Overlap
Chateau
Inside
Overlap
Chateau Forge
Inside
Overlap
Galleria
Inside
CF Inside
Note: Finishing strips may be used to aid in position-
ing of non-combustible facing materials for some of the
facing and decorative front combinations specified in
the table above. They must be removed following fin-
ishing work. See Figure 13.8.
Heat & Glo • 6000CLX-IPI-S, 6000CLX-IPI-T, 8000CLX-S, 8000CLX-IPI-T • 2166-900 Rev. AN • 2/16
B
DO NOT REMOVE
A B
39-3/4 41
1010 1041
41-3/4 48
1060 1219
FINISH MATERIAL
THICKNESS
Any
1 inch or less
Greater than 1 inch
1 inch or less
Greater than 1 inch
1 inch or less
Greater than 1 inch
1 inch or less
Greater than 1 inch
1 inch or less
Greater than 1 inch
Any
Finishing Material:
1 Inch Thick or Less
Remove Finishing Strips. See Figure 13.8.
NOTICE: Remove finishing strips before firing appliance.
SEE
FIGURE
13.6
13.4
13.5
13.4
13.5
13.4
13.5
13.4
13.5
13.4
Figure 13.5 Finishing Material 1 Inch Thick or Less
13.5
13.6
1 in. MAX.
DOOR FINISHING MATERIAL
(TOP EDGE)
Finishing materials 1 inch maximum thick.
Stop finishing material flush with opening.
FINISHING STRIP NOT USED
(See Figure 13.7 for
removal instructions)
NON-COMBUSTIBLE
FINISHING MATERIAL
53