General Cip Configuration Procedure - Alcatel SPEED TOUCH PRO User Manual

10 Configuration and Use - CIP & IP Routing
10.2.1

General CIP Configuration Procedure

Decision procedure
100 / 238
Due to the many decisions that must be made in order to be able
to configure the STPro to be an active member of a LIS, the
procedure to be followed is best retrieved from the following
decision table:
Step Decision and/or Action
Are you configuring the STPro for an existing LIS ?
1
Answer Action and Description
Yes You must retrieve the LIS IP parameters to
which your local configuration must adhere to.
See topic 'Configuration for an Existing LIS' of
subsection 10.2.2.
No You can create the LIS with IP parameters of
your choice. See topic 'Creating a New LIS' of
subsection 10.2.2.
In case you create a new LIS, you must create
the LIS at both end of the DSL connection, i.e.
at the local, and on the remote side.
2 Retrieve the appropriate LIS parameters, and check on
which VCs (identifiable by their VPI/VCI values) your service
provider enabled the CIP packet service.
3 If needed, create a CIP phonebook entry, i.e. a CIP PVC, in
the 'Phonebook' web page.
4 Is the remote access router a RFC1577/RFC2225 compliant device,
e.g. another STPro?
Answer Action and Description
Yes The remote access router will respond to
'InATMARP' requests, thus the CIP PVC can be
implicitly assigned to the CIP member.
The remote access router will not respond to
No
'InATMARP' requests submitted by the STPro,
thus the CIP PVC must be explicitly assigned to
the CIP member.
5 If needed, create a CIP member in the 'CIP Interfaces' table
of the 'CIP' page.
6 Add appropriate IP routes to the STPro via the 'IP route'
table on the 'Routing' page.
7 Add appropriate IP routes in you PC(s).
See
10.2.2
10.2.2
10.4
See
10.2.3
10.2.4
10.4
10.2.6
10.2.6
3EC 17059 ABAA TCZZA Ed. 01