General Cip Configuration Procedure - Alcatel AST570 User Manual

12 Configuration and Use - CIP & IP Routing
12.2.1

General CIP Configuration Procedure

Decision procedure
132 / 300
Due to the many decisions that must be made in order to be able
to configure the AST570 to be an active member of a LIS, the
procedure to be followed is best retrieved from the following
decision table:
Step Decision and/or Action
Are you configuring the AST570 for an existing LIS ?
1
Answer Action and Description
Yes You must retrieve the LIS IP parameters to
which your local configuration must adhere to.
See topic 'Configuration for an Existing LIS' of
subsection 12.2.2.
No You can create the LIS with IP parameters of
your choice. See topic 'Creating a New LIS' of
subsection 12.2.2.
In case you create a new LIS, you must create
the LIS at both end of the DSL connection, i.e.
at the local, and on the remote side.
2 Retrieve the appropriate LIS parameters, and check on
which VCs (identifiable by their VPI/VCI values) your SP
enabled the IPoA connection service.
3 If needed, create a CIP phonebook entry, i.e. a CIP PVC in
the 'Phonebook' page.
4 Is the remote access router an RFC1577/RFC2225 compliant device,
e.g. another AST570?
Answer Action and Description
Yes The remote access router will respond to
'InATMARP' requests, thus the CIP PVC can be
implicitly assigned to the CIP member.
The remote access router will not respond to
No
'InATMARP' requests submitted by the AST570,
thus the CIP PVC must be explicitly assigned to
the CIP member.
5 If needed, create a CIP member in the 'CIP Interfaces' table
of the 'CIP' page.
6 Add appropriate IP routes to the AST570 via the 'IP route'
table on the 'Routing' page.
7 Add appropriate IP routes in you PC(s).
See
12.2.2
12.2.2
12.4
See
12.2.3
12.2.4
12.4
12.2.6
12.2.6
3EC 17766 AAAA TCZZA Ed. 04