Bridged Pppoe Configuration - Alcatel SPEED TOUCH PRO User Manual

7 Configuration and Use - Bridged PPPoE
7.3

Bridged PPPoE Configuration

Introduction
Bridging configuration
60 / 238
As the Bridged PPPoE packet service implies nothing more than
using the STPro Transparent Bridging packet service, no specific
configuration for Bridged PPPoE is required on the STPro.
However, you may need to configure the Transparent Bridging
packet service of the STPro in order to meet the requirements of
your SP regarding VC(s) and encapsulation.
Proceed as follows:
1. Browse to the 'Bridge' page.
2. Select the phonebook entry from the 'Bridge port' pop down
list.
Note: In case the presented phonebook entries do not suite your desired
configuration, you must firstly create a correct phonebook entry. See
section 11.3 for more information.
3. For this entry, select the correct encapsulation method from
the 'Encap' pop down list (per default set to LLC/SNAP).
4. Click
See section 6.3 for more information.
and to finish the procedure.
3EC 17059 ABAA TCZZA Ed. 01