Inspect fan housing gasket (1)
and replace if necessary.
– Fit the fan housing and tighten
down the screws firmly
–
see
3.5.
Before fitting the screw (1) above
the spring, insert a 5 mm
diameter drift or punch in the hole
(arrow) to prevent the bearing
plug, with spring, slipping out of
the tank housing.
Reassemble all other parts in the
reverse sequence.
64
10
Master Control/
Handle System
10.1
Switch Shaft
– Remove the carburetor
–
see
12.2.1.
1
1
1
Remove the short circuit wire (1)
from the switch shaft (2).
1
Pry the switch shaft (1) out of the
tank housing (2).
Carefully pull the switch shaft (1)
out of the pivot mount (3).
Install in the reverse sequence.
2
2
3
MS 270, MS 280