Fit the handle molding so that the
lugs engage the recesses.
Press down the end of the handle
molding until the retainers snap
into position in the handle
housing.
66
10.2.2 Machines with
QuickStop Super
– Remove the carburetor box cover
–
see
6.4.
Push the two retainers (arrows)
on the underside of the hand
guard apart and remove the
handle molding upwards.
1
2
Use a 3 mm drift to drive the
needle roller (2) out of the
interlock lever (1). Remove the
interlock lever.
3
2
1
Use a 4.5 mm drift to drive the
bushing (1) out of the interlock
lever (2) and then remove the
torsion spring (3).
1
To remove the switch lever (1), tilt
it back.
Ø
Disconnect brake cable (1) from
switch lever (2).
– Use a 3 mm drift to drive the
needle roller out of the switch
lever.
MS 270, MS 280
1
2