Rope Rotor - Stihl MS 270 User Manual

Installing
– Coat pegs of new pawls with
graphite grease – see
Reassemble all other parts in the
reverse sequence.
MS 270, MS 280
8.4

Rope Rotor

– Remove the fan cover with
rewind starter –
14.
Relieving tension of rewind
spring:
The rewind spring will not be under
tension if the starter rope is broken.
– Pull out the starter rope about
5 cm and hold the rope rotor
steady.
– While still holding the rope rotor
steady, take three full turns off the
rope rotor.
– Pull out the rope with the starter
grip and slowly release the rope
rotor.
– Remove the starter rope from the
rotor.
Use a screwdriver or pliers to
carefully remove the spring
clip (1) from the starter post.
see 8.2.
Remove the washer (1) from the
starter post.
– Carefully pull the rope rotor off
the starter post.
The rewind spring may pop out and
unwind if rope rotor is not removed
very carefully.
– Remove the starter rotor
– see
Reassemble in the reverse
sequence.
– Install the starter rope –
– Coat bore in rope rotor with
STIHL special lubricant –
1
2
1
Fit the rotor on the starter post
so that the lug (1) on the rope
rotor slips behind the inner spring
loop (2).
– Tension the rewind spring
– see
1
8.5.
see 8.5.
see 14.
8.5.2.
55