8.
MASTER CONTROL/HANDLE SYSTEM
8.1
Interlock Lever/Throttle Trigger
• Remove the fan housing - see 6.2.
• Take the torsion spring (1) off the
interlock lever (2).
• Remove the interlock lever.
• Remove the throttle trigger.
STIHL 019 T
• Pull the throttle cable out of
throttle trigger.
• Take the torsion spring off the
throttle trigger.
Reassemble in the reverse
sequence.
8.2
Switch Shaft
- Remove the throttle trigger
- see 8.1.
• Pull contact sleeve of short
circuit wire out of switch shaft.
• Pull out the switch shaft.
Reassemble in the reverse
sequence.
• It is necessary to push the
contact spring slightly forward to
install the switch shaft.
36