Panasonic AJ-PX800G Operating Instructions Manual page 200

5
Press the <THUMBNAIL> button to switch to the thumbnail screen, and from the thumbnail, playback the clip you just recorded.
Ensure that the clip plays back properly.
6
If two cards are inserted in the P2 card slots, press the USER button to which [SLOT SEL] is assigned and switch the target P2
card.
2 3
Perform steps to and step
Inspecting the audio level automatic adjustment
1
Press the <AUDIO> button to display the [AUD02:INPUT] screen of SmartUI.
2
Set the [IN] in CH1/CH2 to [FRONT].
3
Set the [LVL] in CH1/CH2 to [AUTO].
4
Turn the microphone connected to the <MIC IN> terminal to an appropriate audio source, and ensure that both level displays for
CH1/CH2 change according to the audio volume.
Inspecting the audio level manual adjustment
1
Press the <AUDIO> button to display the [AUD02:INPUT] screen of SmartUI.
2
Set the [IN] in CH1/CH2 to [FRONT].
3
Set the [LVL] in CH1/CH2 to [MANU].
4
Press the <AUDIO> button to display the [AUD01:LEVEL] screen of SmartUI.
5
Turn the microphone connected to the <MIC IN> terminal to an appropriate audio source, and adjust the audio volume settings for
CH1/CH2.
6
Select the [+] item of CH1/CH2 to ensure that the level displays increase.
Inspecting the earphones and speaker
1
Adjust the <MONITOR> dial and ensure that the speaker volume changes.
2
Connect earphones to the <PHONES> terminal.
Ensure that the speaker is muted and the output from the microphone is directed to the earphones.
3
Adjust the <MONITOR> dial and ensure that the earphones volume changes.
Inspections for using an external microphone
1
Connect the external microphone to the <AUDIO IN CH1/3> terminal or <AUDIO IN CH2/4> terminal.
2
Set the <LINE>/<MIC> switch to <MIC>.
3
Toggle the microphone input power switch according to the power supply for the external microphone.
f Selection items
- <+48V>: Microphones with an external power supply
- <OFF>: Microphones with an internal power supply
4
Press the <AUDIO> button to display the [AUD02:INPUT] screen of SmartUI.
5
Set the [IN] in CH1/CH2 to [REAR].
6
Turn the microphone to an audio source, and confirm that the audio level display on the viewfinder or on SmartUI changes
according to the audio volume.
You can check each channel by connecting one microphone to each channel.
Inspections for the clock, time code, and user bits
1
Set the user bits as needed.
For details, refer to "User bits settings" (page 92).
2
Set the time code.
For details, refer to "Setting the time code" (page 94).
3
Press the <HOME> button to display the [HOME] screen of SmartUI.
4
Press the <COUNTER> button to display [TCG].
5
Press the <SETUP> button to display the [SET01:TC/UB] screen of SmartUI.
Chapter 11 Maintenance and Inspection — Inspections before shooting
5
to ensure that the recording and playback functions operate properly.
– 200 –