Locking And Unlocking; Switching Power - Subaru Forester 2016 Owner's Manual

Access key if access key
does not operate properly
CAUTION
Keep metallic objects, magnetic
sources and signal transmitters
away from the area between the
access key and the push-button
ignition switch. They may interfere
with the communication between
the access key and the push-button
ignition switch.
If the locking/unlocking procedures, power
switch procedures or engine start proce-
dures cannot be operated because of
strong radio signals in the surrounding
area or a low battery condition of the
access key, perform the following proce-
dure. When the battery of the access key
is discharged, replace it with a new one.
Refer to Replacing battery of access key
11-45.
In case of emergency/Access key

Locking and unlocking

1) Release button
2) Mechanical key
While pressing the release button of the
access key, take out the mechanical key.
Lock or unlock the driver s door with the
mechanical key according to the proce-
dure described in Locking and unlocking
from the outside 2-5.
NOTE
After locking or unlocking, be sure to
reinsert the mechanical key into the
access key.
if access key does not operate properly

Switching power

1. Apply the parking brake.
2. Shift the select lever into the P
position.
3. Depress the brake pedal.
4. Hold the access key with the buttons
facing you, and touch the push-button
ignition switch with it.
When the communication between the
access key and the vehicle is completed,
a chime (ding) will sound. At the same
time, the status of the push-button ignition
switch changes to either of the following.
. When the keyless access with push-
button start system is deactivated:
ACC
. Under other conditions: ON
5. When the keyless access with push-
9-17
CONTINUED