Subaru Forester 2016 Owner's Manual page 242

3-100
Instruments and controls/Mirrors
NOTE
If any of the HomeLink
®
already programmed for other devices,
skip step 2 because it clears the
memory of all three buttons.
1) HomeLink button 1
®
2) HomeLink button 2
®
3) HomeLink button 3
®
2. Press and hold the two outer
HomeLink buttons (button 1 and button
®
3) until the indicator light begins to flash
(after approximately 20 seconds). Then
release both buttons.
3. Hold the end of the garage door
opener s hand-held transmitter between
1 and 3 inches (25 and 76 mm) away from
the HomeLink button you wish to pro-
®
gram.
4. Simultaneously press and hold both
the hand-held transmitter button and the
buttons are
desired HomeLink
lease the buttons until step 5 has been
completed.
NOTE
Some gate operators and garage door
openers may require you to replace
this programming step 4 with proce-
dures in
gates and garage door openers in
Canada
5. Hold down both buttons until the
HomeLink
®
slowly then rapidly. When the indicator
light flashes rapidly, both buttons may be
released. (The rapidly flashing light indi-
cates successful programming of the new
frequency signal.)
6. Press and hold the programmed but-
ton and check the HomeLink
light. If the indicator light stays on con-
tinuously, your garage door should acti-
vate and the programming is completed.
If the indicator light flashes rapidly for 2
seconds and then stays on continuously,
your garage door opener may be pro-
tected by a rolling code feature. In this
case you need to perform the additional
steps that are described in Programming
button. DO NOT re-
®
Programming for entrance
3-101.
indicator light flashes, first
indicator
®
rolling-code-protected garage door open-
ers in the U.S.A. 3-100.
Programming rolling-code-pro-
tected garage door openers in
the U.S.A.
If your garage door opener has a rolling
code feature, program the HomeLink
Wireless Control System for it by following
steps 1 through 5 in Garage door opener
programming in the U.S.A.
continue with the following steps.
NOTE
The assistance of a second person
may make the programming quicker
and easier.
1. Locate the training button on the
garage door opener motor head unit.
®
3-99. Then