4. The system will notify you that the
setting is complete.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
Hazard warning flasher setting
1. Perform the preparation steps accord-
ing to Preparation for car settings
2. Operate the
or
select the Hazard Warning Flasher item.
Then pull the
/SET switch toward you.
Instruments and controls/Multi function display
3. The current setting will be displayed.
Pull the
/SET switch toward you to
3-72.
enter the selection mode.
switch to
4. Select On or Off by operating the
or
switch. Then pull the
switch toward you.
3-73
/SET
CONTINUED