Ransomes 933308G Maintenance & Parts Manual page 13

EC
Hydro
Midsize
SETTING CUTTERDECK HEIGHT
CUTTERDECK POSITION
.
1. Support rear of power unit.
2. Place blocks under both outside edges of cutter-
deck at B. See Block chart below.
3. Remove (2) upper deck mounting bolts C.
4. Loosen (2) lower deck mounting bolts D several
turns. Loosen enough to allow easy movement
of the rear of cutterdeck. Allow deck to set down
on blocks or if deck is being raised, allow the
front casters to sit on the fl oor.
5. Reinstall upper deck mounting bolts C according
to the chart for the cut height desired.
6. Tighten all bolts and reinstall belt cover.
7. Remove rear support and blocks under the deck.
8. Your side discharge mower will give you the best
cut if the very tip of the front blade is 1/8" to 1/4"
lower then the rear of the rear blade.
ASSEMBLY/SET-UP INSTRUCTIONS
11