Running Tests
Perform System Diagnostic Test
To run a System Diagnostic Test:
1. Access the System Diagnostic Test menu by pressing
2. Start the system diagnostic test by pressing
•
Follow instructions on the local panel to set up conditions for the test.
•
If the test completes successfully, the System Diagnostic Test menu is
displayed.
•
If a fault occurs, an error message is displayed.
3. To cancel the test, press
OPERATOR" message.
4. To return to the first System Diagnostic Test menu, press
Print SMPTE Pattern
To run a Print SMPTE Pattern test:
1. From the System Diagnostic Test menu, press
Pattern display.
2. To print the SMPTE pattern menu, press
•
Follow instructions on the local panel to set up conditions for the test.
•
If the print completes successfully, the Print SMPTE Pattern menu is
displayed.
•
If a fault occurs, an error message is displayed.
3. To cancel the print, press
OPERATOR" message.
4. To return to the first Print SMPTE Pattern menu, press
2002 March Rev. E
1340744
Enter
. The system displays a "TEST CANCELLED BY
Exit
.
Enter
. The system displays a "TEST CANCELLED BY
Exit
Troubleshooting
.
Test
.
.
Exit
to access the Print SMPTE
.
Exit
4-17