System Setup - Kodak dryview 8300 User Manual

System Setup

The 8300 Laser Imager provides setup menus that can be used to configure the
system by adjusting the default settings (parameters) that control functions such as
printing or image density. Default settings are the values that apply when you switch
on the imager.
Note
When your imager is installed, it is set up to work for your environment, so you
should rarely need to access and change the default function settings.
The parameter function menus available on a particular imager differ according to
the type of input to the system. Imager input options are classified as:
•
Digital
•
Analog
•
Small Computer Systems Interface (SCSI)
•
Network
The parameters for each of these system types are listed on the following two
pages. A menu is available for each listed parameter. (Submenus can be accessed
from the main parameter menu.)
After the parameter list on the following pages, sequence flow charts of the main
parameter menus are provided. The flow charts include references to descriptions of
the menus provided alphabetically in Table 2-1 at the end of this section.
2002 March Rev. E 1340744
Controls and Indicators
2-5