Removing, stripping down and assem-
bling cylinder head
Removing camshafts
Remove the bearing caps (1) for the thrust bear-
•
ings first, to prevent tilting.
Release tension uniformly at radial bearing
•
caps (2) and remove them.
Take out the camshafts.
•
Removing cylinder head
Unscrew the cylinder head bolts (3) with Torx in-
•
sert, BMW No. 00 2 610.
Strike the cylinder head lightly with a plastic-
•
faced hammer to dislodge it.
Removing bucket-type tappets
Using special suction tool, BMW No. 11 3 251,
•
pull bucket tappets (5) out of the cylinder head.
Make a note of which tappet belongs to which
•
valve.
11.22
Downloaded from
www.Manualslib.com
5
manuals search engine
3
2
1
4
LT110270