Charger Installation - AT&T EL42208 User Manual

Getting started
Telephone base & charger installation
If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL)
through your telephone lines, you must install a DSL filter between the
telephone base and the telephone wall jack. The filter will prevent noise
and caller ID problems caused by DSL interference. Please contact your DSL
service provider for more information about DSL filters.
Install the telephone base and charger as shown below.
Telephone base installation
1. Plug the small
end of the power
adapter into the
power jack on
the underside of
the telephone
base.
5. Plug the
large end of
the power
adapter into an
electrical outlet
not connected
to a wall switch.

Charger installation

NOTES:
1. Use only the supplied rechargeable battery, replacement battery (part number Use only the supplied rechargeable battery, replacement battery (part number
89-1332-00-00) or equivalent. To order a replacement battery, visit our website at
www.telephones.att.com
1 (866) 288-4268
2. This power adapter is intended to be correctly oriented in a vertical or floor mount position.
The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-
the-table or cabinet outlet.
DSL filter
(available from your DSL Internet
provider)
Telephone line cord
1 (800) 222-3111
or call
.
6
2. Plug one end of
the telephone
line cord into the
telephone jack
on the underside
of the telephone
base.
3. Route cords
through slots.
4. Plug the other
end of the
telephone line
cord into a
telephone jack.
Plug the power
adapter into an
electrical outlet not
connected to a wall
switch.
.
In Canada, dial