Center Wall Assembly; Locating And Removing The Battery - HP ProLiant BL e-Class System Maintenance And Service Manual

Removal and Replacement Procedures
3. Place the server blade on a level, nonconductive surface.
4. Locate and remove the battery on the server blade.
Figure 2-24: Locating and removing the battery
NOTE: Figure 2-24 shows the ProLiant BL10e server blade.
Reverse steps 1 through 4 to replace the battery.

Center Wall Assembly

To remove the center wall assembly:
1. Power down each server blade. See the "Powering Down a Server Blade" section in this
chapter.
2. Power down the enclosure. See the "Powering Down the Enclosure" section in this
chapter.
3. Disconnect all cables and power cords from the AC power source.
4. Disconnect all cables and power cords from the enclosure rear panel.
5. Remove all server blades and server blade blanks. See the "Removing a Server Blade"
and the "Removing a Server Blade Blank" sections in this chapter.
6. Remove both hot-plug power supplies. See the "Hot-Plug Power Supplies" section in this
chapter.
2-28
HP CONFIDENTIAL Codename: Kerr Part Number: 249066-004 Last Saved On: 5/12/03 3:00 PM
CAUTION: Integrated Administrator security settings are assigned to server blade bays, not
to server blades. If server blades change locations within the enclosure, Integrated
Administrator settings must also be adjusted to ensure accurate security. Refer to the HP
ProLiant BL e-Class Integrated Administrator User Guide for more information on security
settings.
HP ProLiant BL e-Class System Maintenance and Service Guide