Removing A Server Blade Blank; Removing A One-Bay Server Blade Blank; Removing A Five-Bay Server Blade Blank - HP ProLiant BL e-Class System Maintenance And Service Manual

Removing a Server Blade Blank

To remove the server blade blank:
1. Press the ejector tabs on the server blade blank (1).
2. Remove the server blade blank from the enclosure (2).
Figure 2-8: Removing a one-bay server blade blank
Figure 2-9: Removing a five-bay server blade blank
Reverse steps 1 and 2 to replace the server blade blank.
HP ProLiant BL e-Class System Maintenance and Service Guide
HP CONFIDENTIAL Codename: Kerr Part Number: 249066-004 Last Saved On: 5/12/03 3:00 PM
CAUTION: To avoid thermal events, be sure that each server blade bay contains a server
blade or server blade blank while the enclosure is powered up.
Removal and Replacement Procedures
2-13