Opening The Access Door; Removing The Enclosure From The Rack - HP ProLiant BL e-Class System Maintenance And Service Manual

Table of Contents

Advertisement

Removal and Replacement Procedures
8. Loosen the thumbscrews on the front of the enclosure (1).
9. Remove the enclosure from the rack (2).
IMPORTANT: Pull the enclosure out using the handles. Pulling the enclosure by the thumbscrews
damages the thumbscrews.
Figure 2-11: Removing the enclosure from the rack
Reverse steps 1 through 9 to install the enclosure into the rack.

Opening the Access Door

To open the access door:
1. Power down each server blade. See the "Powering Down a Server Blade" section in this
chapter.
2. Power down the enclosure. See the "Powering Down the Enclosure" section in this
chapter.
3. Disconnect all cables and power cords from the AC power source.
4. Disconnect all cables and power cords from the enclosure rear panel.
5. Remove all server blades and server blade blanks. See the "Removing a Server Blade"
and the "Removing a Server Blade Blank" sections in this chapter.
6. Remove the enclosure from the rack. See the "Removing the Enclosure from the Rack"
section in this chapter.
2-16
HP CONFIDENTIAL Codename: Kerr Part Number: 249066-004 Last Saved On: 5/12/03 3:00 PM
CAUTION: Integrated Administrator security settings are assigned to server blade bays, not
to server blades. If server blades change locations within the enclosure, Integrated
Administrator settings must also be adjusted to ensure accurate security. Refer to the HP
ProLiant BL e-Class Integrated Administrator User Guide for more information on security
settings.
HP ProLiant BL e-Class System Maintenance and Service Guide

Advertisement

Table of Contents
loading

Table of Contents