Table of Contents
Advertisement
Message
56 Serial Port <x>
Disabled
56 Standard Serial
Disabled
56 Parallel Port <x>
Disabled
56 Std Parallel Port
Disabled
56 USB Port <x>
Disabled
56 Standard USB Port
Disabled
58 Input Config Error
58 Output Config
Error
58 Too Many Disks
Installed
58 Too Many Flash
Options
59 Incompatible
<device>
61 Defective Disk
62 Disk Full
What this message means
Data has been sent to the printer
through a serial port, but the serial port
is disabled.
Data has been sent to the printer
through a parallel port, but the parallel
port is disabled.
Data has been sent to the printer
through a USB port, but the USB port
is disabled.
Either too many drawers with matching
trays are attached to the printer or the
input configuration is invalid. (For
example, a duplex unit is installed
between Tray 3 and Tray 4.)
Too many output options have been
attached to the printer.
Too many hard disks are installed on
the printer. The printer only supports
one hard disk at a time.
Too many flash memory options are
installed on the printer.
You have installed an incompatible
device.
The printer detects a defective hard
disk.
There is not enough memory on the
hard disk to store the data sent to the
printer.
86
What you can do
• Press Go to clear the message. The
printer discards any data received
through the serial port.
• Make sure the Serial Buffer menu item in
the Serial Menu is not set to Disabled.
See also:
Serial Buffer
• Press Go to clear the message. The
printer discards any data received
through the parallel port.
• Make sure the Parallel Buffer menu item
in the Parallel Menu is not set to
Disabled.
See also:
Parallel Buffer
• Press Go to clear the message. The
printer discards any data received
through the USB port.
• Make sure the USB Buffer menu item in
the USB Menu is not set to Disabled.
See also:
USB Buffer
Turn off and unplug the printer. Remove the
additional drawers or reconfigure the
offending option. Plug in the printer and
turn it on.
See also: Setup Guide
Turn off and unplug the printer. Remove the
additional output option(s). Plug in the
printer and turn it on.
See also: Setup Guide
Turn off and unplug the printer. Remove the
excess hard disks from the printer. Plug in
the printer and turn it on.
See also:
Removing memory and option
cards
Turn off and unplug the printer. Remove the
excess flash memory. Plug in the printer
and turn it on.
See also:
Removing memory and option
cards
Remove the device and press Go to clear
the message.
• Press Go to clear the message and
continue printing.
• Install a different hard disk before you
perform any operations that require one.
See also: Setup Guide
• Press Go to clear the message and
continue processing. Any information not
previously stored on the hard disk is
deleted.
• Delete fonts, macros, and other data
stored on the hard disk.
Advertisement
Table of Contents
