Table of Contents
Advertisement
Message
Programming Error
P<x>
Queuing and Deleting
Jobs
Queuing Jobs
Ready
Ready Hex
Reattach <device>
Remove Paper
<specified bin>
Resetting Active Bin
Resetting Fuser Cnt
Value
Resetting the Printer
What this message means
An error occurred while the printer was
programming code into memory.
The printer is deleting one or more
held jobs and sending one or more
jobs to print.
The printer is sending one or more
held jobs to print.
The printer is ready to receive and
process print jobs.
The printer is in Hex Trace mode and
is ready to receive and process print
jobs.
The specified device is either not fully
connected to the printer or is
experiencing a hardware failure.
The specified output bin, or bins, is full. Remove the stack of paper from the
The printer is resetting to the active bin
in a linked set of bins.
The printer is resetting the counter that
tracks wear on the fuser.
The printer is resetting to the current
default settings. Any active print jobs
are canceled.
80
What you can do
Correct the problem specified on the
second line of the display:
• P1050—A network file was used to
program a non-network printer, or a non-
network file was used to program a
network printer.
• P109—An update file was used to
program the printer, but the information
did not fit within the space allocated in
the Master Boot Record.
• P112—An upddle.fls file was used to
update the DLE code on a printer with a
firmware card installed, but the DLE was
not found on the firmware card.
• P200—No firmware card is installed.
Wait for the message to clear.
See also:
Printing and deleting held jobs
Wait for the message to clear.
See also:
Holding a job in the printer
Send a job to print.
• Send a job to print. All data sent to the
printer is printed in hexadecimal and
character representation. Control strings
are printed, not executed.
• Turn the printer off and then on to exit
Hex Trace mode and return to Ready
status.
• Reestablish communication by removing
the specified device and reattaching it to
the printer.
• Press Go to clear the message and
continue printing without using the
device.
• In the case of a hardware failure, turn
the printer off and back on. If the error
recurs, turn the printer off, remove the
specified device, and call for service.
See also:
Calling for service
specified bin(s) to clear the message.
Wait for the message to clear.
Wait for the message to clear.
Wait for the message to clear.
See also:
Changing menu settings
Advertisement
Table of Contents
