Table of Contents
Advertisement
Message
Restore Held Jobs.
Go/Stop?
Restoring Factory
Defaults
Restoring Held Job
xxx/yyy
Restoring Held Jobs
Serial <x>
Setup Required
Staples Low
Std Bin Full
Supplies
Tray <x> Empty
Tray <x> Low
What this message means
Someone reset the printer or turned it
on, and the printer detects Print and
Hold jobs stored on the hard disk.
The printer is restoring the factory
default printer settings. When factory
default settings are restored:
• All downloaded resources (fonts,
macros, symbol sets) in the printer
memory are deleted.
• All menu settings return to the
factory default setting except:
– The Display Language setting in
the Setup Menu.
– All settings in the Parallel Menu,
Serial Menu, Network Menu,
USB Menu, and Fax Menu.
The printer is restoring held jobs from
the hard disk.
Note: xxx represents the number of
the job being restored. yyy represents
the total number of jobs to be restored.
The printer is restoring held jobs from
the hard disk.
A serial interface is the active
communication link.
• When you unpacked the printer, you
left a piece of packing material
inside.
• A hardware component, such as an
optional paper drawer, has not been
installed correctly.
The stapler has only a few staples
remaining.
The standard bin is full.
At least one of the printer supplies
requires attention. For example, you
may have a toner cartridge that is low
on toner.
The specified tray is out of paper.
The specified tray is low on paper.
81
What you can do
• Press Go. All Print and Hold jobs on the
hard disk are restored to printer memory.
• Press Return or Stop. No Print and
Hold jobs are restored to printer
memory. The printer returns to the
Ready state.
See also:
Holding a job in the printer
Wait for the message to clear.
See also:
Restoring factory default
settings
• Wait for the message to clear.
• Select the Abort Restore menu item in
the Job Menu.
See also:
Holding a job in the printer
Wait for the message to clear.
See also:
Holding a job in the printer
Wait for the message to clear.
• Remove all packing material from inside
the printer.
• Correctly install the component.
See also: Setup Guide
• Press Go to continue printing.
• Install a new staple cartridge to clear the
message.
Remove the stack of paper in the bin to
clear the message.
Press Menu to open the Supplies Menu
and identify which supply item needs
replacing. Replace the appropriate printer
supplies.
Load paper in the tray to clear the
message.
See also:
Loading the trays
Add paper to the tray to clear the message.
See also:
Loading the trays
Advertisement
Table of Contents
