Table of Contents
Advertisement
Menu Item
Purpose
Staple Alarm
To specify how the printer responds
when it is out of staples.
Toner Alarm
To specify how the printer responds
when it is low on toner.
Wait Timeout
To specify the amount of time (in
seconds) the printer waits to receive
additional bytes of data from the
computer. When this timeout expires,
the print job is canceled.
Wait Timeout is only available when
you use PostScript emulation. This
menu item has no effect on PCL
emulation print jobs.
Values
Off
Load Staples is displayed until
someone loads staples. If an Auto
Continue value is selected from the
Setup Menu, the printer resumes
printing after the specified timeout
value.
Single*
Printer stops printing, displays Load
Staples, and sounds three quick
beeps.
Continuous
Printer stops printing, displays Load
Staples, and repeats three beeps
every 10 seconds until the staple
cartridge is replaced.
Off
An error message is displayed until
someone replaces the toner cartridge.
If an Auto Continue value is selected
from the Setup Menu, the printer
resumes printing after the specified
timeout value.
Single*
Printer stops printing, displays an error
message, and sounds three quick
beeps.
Continuous
Printer stops printing, displays an error
message, and repeats three beeps
every 10 seconds until the toner
cartridge is replaced.
Disabled
Disables Wait Timeout.
15...65535
Specifies the amount of time the
(40*)
printer waits for additional data before
it cancels the job.
69
Advertisement
Table of Contents
