Ricoh M001 Service Manual page 145

The certification update request has been received from the GW URL,
the GW URL was notified of the results of the update after it was
17
completed, but an certification error has been received, and the
rescue certification is being recorded.
The rescue certification of No. 17 has been recorded, and the GW
18
URL is being notified of the failure of the certification update.
CERT:Error
Displays a number code that describes the reason for the request for update
of the certification.
0 Normal. There is no request for certification update in progress.
Request for certification update in progress. The current certification
1
has expired.
5816 068
An SSL error notification has been issued. Issued after the certification
2
has expired.
Notification of shift from a common authentication to an individual
3
certification.
4 Notification of a common certification without ID2.
5 Notification that no certification was issued.
6 Notification that GW URL does not exist.
5816 069 CERT Up ID
5816 083 Firm Up Status
5816 084 Non-HDD Firm Up
SM
Printer Engine Service Mode
The ID of the request for certification.
Displays the status of the firmware update.
This setting determines if the firmware can be
updated, even without the HDD installed.
0: Not allowed update
1: Allowed update
5-31 M001