(2) Detaching and refitting the heater lamp, heat roller, fuser thermistor, thermal cutout, and press roller
<Procedure>
1. Remove the fuser unit (See P.1-5-8).
2. Remove the two screws and terminal.
3. Remove the heater lamp.
* Seat the heater lamp aligning its wattage
mark and welding mark faced with the cor-
rect direction and side.
1-5-10
Screw
Fuser gear
Welding side
Service Manual
Heater lamp
Rating
marking
Screw
Terminal
Heater lamp
Figure 1-5-13
Y107330-8