Problem
(12)No transfer bias
is output.
(13)The message
requesting paper to
be loaded is shown
when paper is
present in the paper
cassette.
(14)A paper jam in
the paper feeding/
conveying section or
fuser section is indi-
cated when the
power switch is
turned on.
(15)The indicator
requesting cover to
be closed is dis-
played when the top
cover is closed.
Y107330-8
Causes
Poor contact of transfer
bias terminal and transfer
bias terminal (J1, J2, J3) on
the engine/high voltage
PWB.
Defective engine/high volt-
age PWB.
Defective paper sensor on
the engine/high voltage
PWB.
A piece of paper torn from
paper is caught around reg-
istration sensor or exit sen-
sor.
Defective registration sen-
sor on the engine/high volt-
age PWB.
Defective exit sensor on the
power source PWB.
Defective interlock switch
on the engine/high voltage
PWB.
Check procedures/corrective measures
(See P.1-5-14).
Replace the engine/high voltage PWB (See P.1-5-14).
Check and remove if any.
Replace the engine/high voltage PWB (See P.1-5-14).
Replace the power source PWB (See P.1-5-14).
Check for continuity across the interlock switch. If there is no con-
tinuity when the interlock switch is on, replace the engine/high
voltage PWB (See P.1-5-14).
Service Manual
1-4-23