IBM eserver xSeries 350 User Reference Manual page 115

Code Function
215 CD-ROM
217 Hard disk drive
264 Magnetic tape
drive
301 Keyboard
Result
Stopped The CD-ROM drive is not present
Failed BIOS drive # n (where n is the drive bay number) Call for service.
Stopped Test setup error: No tape drive found
Failed The load/mount test failed for device n on
adapter m
(where n is the number of the device and m is the
adapter number)
The Self-diagnostic failed for device n on adapter
m.
(where n is the number of the device and m is the
adapter number)
The unload/eject test failed for device n on
adapter m
(where n is the number of the device and m is the
adapter number)
The unload/eject push button test failed for
device n on adapter m
(where n is the number of the device and m is the
adapter number)
The Read/Write Self-diagnostic failed for device
n on adapter m
(where n is the number of the device and m is the
adapter number)
Failed On system board keyboard test failed
Text message Action
Verify that the cables are
properly connected to the
CD-ROM drive.
If the problem persists,
call for service.
Check the cable and
power connections to the
drive.
Refer to the information
that is provided with the
tape drive.
If the problem persists,
call for service.
Refer to the information
provided with the tape
drive.
If the problem persists,
call for service.
Note: The push button
test is applicable
only to SCSI tape
drives that have a
push button.
Insert a new tape
cartridge; then, run the
diagnostic test again.
Refer to the information
that is provided with the
tape drive.
If the problem persists,
call for service.
1. Verify that the
keyboard cable is
connected.
2. If the problem
persists, replace the
keyboard cable.
If the problem persists,
call for service.
Chapter 6. Solving problems
103