IBM eserver xSeries 350 User Reference Manual page 104

Table 16. POST error messages.
POST message
00180200 A PCI adapter has requested an I/O address that is not available, or the PCI adapter might be
defective.
Action: 1.
00180300 A PCI adapter has requested a memory address that is not available, or the PCI adapter might be
defective.
Action: 1.
00180400 A PCI adapter has requested a memory address that is not available.
Action: If all memory addresses are being used, you might need to remove an adapter to make
00180500 A PCI adapter ROM error occurred.
Action: Remove the PCI adapters. If you can start the server without the adapters, reinstall each
If you cannot isolate and correct the problem, call for service.
00180600 A PCI-to-PCI bridge error occurred. More than one PCI bus tried to access memory below 1 MB.
Action: Remove the PCI adapter that has the PCI bridge. If you can start the server without the
If you cannot isolate and correct the problem, call for service.
00180700 xxxxyyyy System board PCI device does not respond. (Where xxxx is the PCI vendor ID and yyyy
is the PCI device ID.)
Action: Call for service.
00180800 An unsupported PCI device is installed.
Action: Remove the PCI adapters. If you can start the server without the adapters, reinstall each
If the problem persists, call for service.
00181000 PCI error.
Action: Remove the PCI adapters. If you can start the server without the adapters, reinstall each
If the problem persists, call for service.
01295085 The ECC checking hardware test failed.
Action: Call for service.
01298001 No update data is available for processor 1.
Action: Update the system BIOS to a level that supports the microprocessors that are installed in
92
IBM® xSeries 350: User's Reference
Make sure that the I/O addresses for the PCI adapter and all other adapters are set
correctly in the Configuration/Setup Utility program.
2. If the I/O port resource settings are correct, the PCI adapter might be defective.
Call for service.
Make sure that the memory addresses for all other adapters are set correctly in the
Configuration/Setup Utility program. If the memory resource settings are not
correct, change the settings.
2. If the memory resource settings are correct, the PCI adapter might be defective. Call
for service.
memory address space available to the PCI adapter. Disabling the adapter BIOS on the
adapter might correct the error. Refer to the documentation that comes with the adapter.
adapter one at a time and retest after each is reinstalled. When an adapter fails, replace
it.
adapter, reinstall and retest the adapter. If the adapter fails, replace it.
adapter one at a time and retest after each is reinstalled. When an adapter fails, replace
it.
adapter one at a time and retest after each is reinstalled. When an adapter fails, replace
it.
the server.
Description