IBM eserver xSeries 350 User Reference Manual page 105

Table 16. POST error messages.
POST message
01298002 No update data is available for processor 2.
Action: Update the system BIOS to a level that supports the microprocessors that are installed in
01298101 The update data for processor 1 is incorrect.
Action: Update the system BIOS to a level that supports the microprocessors that are installed in
01298102 The update data for processor 2 is incorrect.
Action: Update the system BIOS to a level that supports the microprocessors that are installed in
01298200 Microprocessor speed mismatch
Action: The microprocessors that are installed do not run at the same speed; install
I9990301 A hard disk drive error occurred.
Action: Call for service.
I9990305 POST could not find an operating system.
Action: Install an operating system. If you have already installed the operating system, check
If you cannot reinstall the operating system, call for service.
I9990650 AC power has been restored.
Action: No action is required. This message appears each time ac power is restored to the server
Other Numbers POST found an error.
Action: Follow the instructions on the screen.
the server.
the server.
the server.
microprocessors with identical speeds.
the drive startup sequence. If the drive sequence is correct, run the diagnostic tests to
verify that the hard disk drive is functioning correctly. If there is a problem with the
hard disk drive (such as a bad sector), you might need to reinstall the operating system.
after an ac power loss.
Description
Chapter 6. Solving problems
93