Day & Time Announcements - AT&T E1828B User Manual

16
1.
CLOCK
Press
The system will announce
the current clock setting,
then announces "To set the
CLOCK
clock, press ."
2.
CLOCK
Press
The system will announce
the current day setting,
then announces "To change
SKIP
the day, press
REPEAT
, to change the
CLOCK
hour, press ."
3.
SKIP
Press
REPEAT
or
until the system announces
the correct day, then press
CLOCK
.
SKIP
4.
Press
REPEAT
or
until the system announces
the correct hour, then press
CLOCK
.
5. SKIP
Press
REPEAT
or
until the system announces
the correct minutes, then
CLOCK.
press
6.
SKIP
Press
REPEAT
or
until the system announc-
es the correct year, then
CLOCK
press . The system
announces the current clock
setting.
Answering system operation
Day & time announcements
To set day & time
Before playing each message, the answering sys-
tem announces the day & time the message was
received.
Before using the answering system, follow the
steps on left to set the day & time, so messages
are dated correctly. If the clock is not set, before
playing messages, the system will prompt "Time
and date not set" each time.
The system uses voice prompts to guide you.
Each time you press
day, hour, minute or year increases or decreases
by one. When you hear the correct setting, press
or
CLOCK to move to the next setting.
To check day & time
You can press CLOCK at any time to hear the cur-
rent day & time without changing it.
NOTES:
1. You can press and hold
or decrease the minute or year by increments of 10.
2. Caller ID provides the time and date. Set the year so that
the day of the week can be calculated from the caller ID
information. After you set the time once, it will thereafter be
set automatically with incoming caller ID information. The
time will be set automatically only if you subscribe to caller
ID service provided by your local telephone company (page
30).
39
SKIP or REPEAT , the
SKIP or REPEAT to increase