Sharp AR-P13 Service Manual page 88

2. WebPage (Status Message)
Message Displayed
READY
Reboot the Machine
Wait
Call for Service
Printer Error : P05
Printer Error : P09
Printer Error : P50
Printer Error : P51
Printer Error : P56
Printer Error : P55
Printer Error : P54
Printer Error : P52
Printer Error : P57
Set Developer Unit.
Set Maincharger Unit.
Dispose of Used Toner.
Misfeed in Copier.
Finisher not Ready.
Stapler not ready.
Examine Stapler.
Set Staple Cartridge.
Please Dispose of Hole Punch Dust
Add Toner.
Close Cover.
Add Paper.
Warming Up
Time for Periodic Maintenance.
Toner near Empty
PCI Information Status
Following errors cannot be applied.
(SCR06, 0Ch, D1) Reboot Warning
(SCR06, 0Ch, D0) During FSMS
(SCR06,08h,D0) Errors that cannot be
recovered
(STER-D0~D6=04h) DMA Buffer Error
(STER-D0~D6=08h) Command Submit
Error
(SS04-06h) PCI Timeout Error
(SS04-00h) Deficiency of Memory
(SS04,05h) Fetal Error
(SS04-04h) PCI Interface Error
(SS04-03h) PRINT SERVER CARD Error H/W reset or turn OFF the power of this
(SS04-01h) NvRAM Error
(SS04-07h) Expanded Memory Error
(SCR06,04h,D0) No developer unit
(SCR06,04h,D1) No maincharger unit
(SCR06,04h,D3) Toner bag full
(SCR06,00h,D0~D4) Jam Status
on the Control Panel.
(SCR06,05h,D1,D2) Finisher Error
(SCR06,0Bh,D3) No Stapler
(SCR06,06h,D0) Staples Jam
(SCR06,0Bh,D2) No Staples
(SCR06, 0Bh, D6) Hole Punch Unit Full
(SCR06,04h,D2) No toner
(SCR06,01h,D0,D1,D2,D3,D4 & SCR06,
0Bh,D1) Cover Open
(SCR06,02h &03h) No Paper
(SCR06, 09h, D0) Warming Up
(SCR06,0Bh,D4) Periodic maintenance
is necessary.
(SCR06,0Bh,D5) Toner Near Empty
5-2
Solution
—
Turn the power OFF and restart.
—
Contact the maintenance service.
Turn OFF the power of this machine and
restart again.
Turn OFF the power of this machine and
restart again.
H/W reset or turn OFF the power of this
machine and restart again.
H/W reset or turn OFF the power of this
machine and restart again.
H/W reset or turn OFF the power of this
machine and restart again.
H/W reset or turn OFF the power of this
machine and restart again.
machine and restart again.
H/W reset. All settings are revised to defaults
except IP Address.
H/W reset or replace the memory.
Install the developer unit correctly.
Install the maincharger unit correctly.
Replace the toner bag.
Remove the jammed paper referring to [HELP]
The finisher is not installed correctly or the tray
capacity is exceeded. Remove paper from the
finisher and make sure that the finisher installed
correctly.
Install the Stapler correctly.
Remove jammed staples.
Supply staples.
Dispose of hole punch dust.
Supply toner.
Close the cover of the machine.
Supply paper.
The printer is being started. Wait for a while.
Contact the maintenance service for periodic
inspection.
Supply toner.