Sharp AR-P13 Service Manual page 120

• Jumper Switch, LED
• Jumper Switch (OP2)
Jumper switch is to set up the operation settings of Print Server Card.
• Setup the Jumper Switch
JUMPER
OP2
* Do not replace any other jumpers (JP2, OP1, OP3~OP7) except OP2. It will not be operated normally if you make any
change in those jumpers.
represents the default setting at the time of shippment from the factory.
Restore the default at NVRAM
• How to restore the default at NVRAM
1. Replace the OP2 jumper to the FACT side.
2. Turn ON the machine.
* When the power is turned ON, the Green LED indicator flashes 3 times, then the
and Amber LED indicators flashes alternately. This indicates the NVRAM restores the
default.
3. Turn OFF the machine.
4. Replace the OP2 jumper to default side.
ON
ON
T.B.
P .A.
FACT
BYPASS
OP6
TEST
OP1
OPERATION
4-18
OP7
OP5
DL1
OP4
OP3
OP2
DL2
Green