Protocols; Printer - Sharp AR-P13 Service Manual

3.3.2

Protocols

Describe the settings for each protocol here.
Setup NetWare
Setup TCP/IP
Setup AppleTalk
3.3.3

Printer

Communication Test can be performed.
Test Printer
Configure Status Page
Printer Status
Enable NetWare
Print Server Name
Print Server Password
Password Retype
Preferred File Server
Preferred NDS Context
Preferred NDS Tree
Print Queue Scan Rate
Ethernet Frame Type
Disable Bindery
Enable TCP/IP
Subnet Mask
Default Gateway
DHCP (Dynamic Host Configuration Protocol)
Base Port Number
Enable LPD Banner
NIC Port
Enable AppleTalk
Zone Name
Printer Name
Select "ASCII" in general, then enter the password and click on "Start Test".
Test data are printed out.
Setting of the printout of Status page.
The Status page is printed out when starting the printer ON if "Printer Status Page on Startup" is checked
on.
The printer status can be confirmed.
To use the printer under the operation of NetWare server or Peer-to-Peer
Utility (IPX/SPX), check it on.
Enter the name of the print server to be created. It must match the setting
of NetWare. "SHA_XXXXXX" is set as default name. This is assigned for
the port name printed to when the Peer-to-Peer Utility (IPX/SPX) is used.
Please do not change the setting in general.
Please do not change the setting in general.
Enter the file server name to be prior. It is available only in bindery mode.
Enter the NDS Context to be prior. It is available only in NDS mode.
Enter the tree name of NDS to be prior. It is available only in NDS mode.
Set the time interval for the print server to scan the print queues in the range
of 1 to 255 seconds. It is set to 1 second as default setting.
Select a frame type you want to preferentially retrieve when more than one
frame type of NetWare are used.
Usually, use the default setting.
Check it on only when using in the NDS mode of NetWare 4.x. Check it off
when using NetWare 3.x or NetWare 4.x in the bindery mode.
Check it on when using this machine in the TCP/IP environment.
Assign the Subnet Mask.
Assign the Default Gateway Address.
Set the DHCP is valid or not. (DHCP is valid as default setting)
Please do not change the setting in general.
Operate the setting for output of banner pages when lpr printing is performed.
Please do not change the setting in general.
Check it on when using this machine in the AppleTalk environment.
Enter a zone name that this machine belongs to.
Display the printer name of this machine. No setting can be made.
4-25