Konica Minolta bizhub 362 Installation Manual page 5

5. Remove the toner supply port.
6. Remove the liner from the Mylar sheet included in
the machine.
7. Attach the Mylar sheets (two places).
Note:
Make sure that the collar is completely covered
with the Mylar sheet.
Collar
Collar
8. Ready a packet of starter and cut off one corner
of the aluminum packet with scissors.
A11UIXC014MA
9. While turning the gear in the direction of the
arrow, pour the packet of starter evenly into the
developer chamber.
Note:
• Turn the magnet roller in the direction of its nor-
mal rotation, and not the backward.
• Not touching the gear of A side.
• Be sure not to let starter get inside the collar.
A11UIXC060MA
10. Remove the Mylar sheets that were attached in
step 7 (two places).
Note:
Discard the removed Mylar sheets.
A11UIXC015MA
E-5
A11UIXC016MA
A
Collar
A11UIXC017MA