Konica Minolta bizhub 362 Installation Manual page 13

36.Touch "Initial Transmission" at the right bottom of
the screen to start initial transmission.
Note:
The Initial Transmission key at the right bottom of
the screen will be displayed only when the Center
ID, the Device ID, the Center Phone No., and the
Device Phone No. are all entered.
37.The CS Remote Care setting screen will be dis-
played when normally connected to the center.
38.Keep touching "END" until the Tech. Rep. Mode
screen is displayed.
39.Touch "Exit" on the Tech. Rep. Mode screen.
Note:
When the Tech. Rep. Mode is finished being dis-
played, turn main power OFF and wait for more
than ten seconds before turning main power back
ON.
<When using an e-mail>
1. Register the Device ID to the application at CS
Remote Care Center. When the Device ID is not
registered, initial connection will not be per-
formed.
2. Remove the phone line modem.
3. Display the Tech. Rep. Mode screen.
(See the Service Manual for how to display the
screen.)
4. Touch "CS Remote Care."
A11UIXC047MA
5. Touch "ID Code."
6. Enter the seven-digit ID using the ten-key pad,
and touch "ID Code" again.
7. Touch "Detail Setting."
8. Touch "RAM Clear."
E-13
A11UIXC040MA
A11UIXC048MA
A11UIXC049MA