Table of Contents
Advertisement
11. P2 Card Nearly Full
One of the bars for remaining MEDIA capacity
starts blinking.
Blinks once per second while recording
continues.
Blinks once per second while recording
continues.
Beeps once per second while recording
continues.
The total remaining capacity of all the P2
cards is two minutes or less.
Continues to operate.
Replace the cards. If there is an empty card
slot, insert a new card.
12. P2 Card Error
Displays “00:00:00:11” in the time code
display. The window continues to flash until
the next operation, even after stopping record
and playback.
If the error occurs during recording, the lamp
flashes four times per second for a period of
about three seconds. The lamp does not light
if the error occurs during playback.
If the error occurs during recording, the lamp
flashes four times per second for a period of
about three seconds. The lamp does not light
if the error occurs during playback.
If the error occurs during recording, the tone
sounds four times per second for a period of
about three seconds. The tone does not
sound if the error occurs during playback.
An error has occurred while recording data to
or playing data from a P2 card.
Stop recording or playback. After recording is
stopped, the P2 card where error occurs is
write protected.
Replace the affected P2 card.
Error Codes
The following error codes are displayed in the display window if an error occurs in the camera:
Confirm the type of warning and refer to the details in the [Warning Description Tables] (page 153) for countermeasures.
E-11
Video initialisation error
E-27
Recording control error
E-30
P2 card removal error
E-34
LCD microcontroller error
E-38
P2 streaming microcontroller error
E-3F
Microprocessor error in the camera control circuit.
E-40
Image sequence, GENLOCK input signal or SDI input signal error
E-63
Something is wrong with the system control microprocessor.
E-6F
Reference signal error.
00:00:00:11
Errors such as recording to P2 card error
13. FAN STOP
No display.
Blinks 4 times per second.
No display.
The FAN STOP indicator blinks while
recording continues.
It does not sound.
The fan is at rest because something is wrong
with it. Alternatively, the FAN MODE item is
set to “OFF”. The menu item FAN MODE is
found in the <OPTION> screen on the
OPTION MENU page.
If the camera-recorder operates with the fan
stopped, then the temperature inside rises.
While the camera-recorder continues to
operate, clips may not be recorded or played
back properly.
Immediately stop using the camera-recorder
and consult your distributor.
1. System Errors
1. System Errors
2. Card removal error
1. System Errors
1. System Errors
1. System Errors
1. System Errors
1. System Errors
7. Recording Error, 8. Number of Clips Exceeded,
12. P2 Card Error
Maintenance and Inspections: Warning System
Advertisement
Table of Contents
