EverFocus PARAGON 264x1 User Manual page 78

Take the computer's values for Subnet Mask and Default Gateway and input them into the DVR; these values
should be exactly the same in both devices. However, you should change the last number of the IP
address. For example, if the IP address of the computer is 192.168.2.101, the DVR's IP address should be
192.168.002.050.
To access the DVR from a computer, simply open Internet Explorer and in the address bar type:
http:// (IP address of the DVR)
Note: The DVR's IP address will only work at the location of the DVR. To connect from a different location
over the Internet, see below.
To set DVR for Internet Connection through router
The next step is to open ports within your router. Log into the router using a PC and open the following ports.
o Ports to open: 80
o If your Internet service provider blocks port 80, you can change it to a different port in the DVR's Network
Menu Setup; open/forward that port instead.
o If you are using a Linksys or D-Link router, see Chapter 8 for basic support on setting up ports. For any
other router, you will need to contact the manufacturer for support.
To access the DVR from a computer simply open Internet Explorer and in the address bar type:
http:// (the IP address given by your internet service provider)
Note: If you changed to a different port other than 80, you will need to include this at the end of the IP
address
http:// (the IP address given by your internet service provider):portnumber
If you have a WAN Dynamic IP address and have opened the ports, go to Chapter 7 to setup DDNS.
71