Rear Panel - EverFocus PARAGON 264x1 User Manual

1.5 REAR PANEL

During initial setup you will be connecting your DVR to multiple input and output devices. This is done via During initial setup you will be connecting your DVR to mul
1) Power Plug: Plug the DC 12V power source provided into the power socket.
2) Network Port: RJ-45 port for
green LED is on, the network connect
3) RS-232 Connector: This 9-pin D
4) RS-485 Connector: For external
attached PTZ devices.
5) Main: This BNC port is for feeding
This BNC port is for feeding the Main Monitor video Out signal to a BNC monitor.
6) Call: This BNC port is the Call
7) Main VGA: This VGA port is for
8) Alarm In: Connect up to 16 alarm input devices
Connect up to 16 alarm input devices.
9) Alarm Out: Connect up to 4 alarm output devices.
Connect up to 4 alarm output devices. The connection options are COM,
alarm out (form "C").
10) Video IN and Video OUT connectors: N and Video OUT connectors: Connect up to 16 cameras to the Video IN connectors (top layer). You
can also connect equipment like monitors to the Video
11) eSATA: Used for connecting an
12) Audio IN: Connect up to four Audio IN cables.
input connection of your choice input connection of your choice.
13) Audio OUT: Only one Audio OUT cable can be connected.
Only one Audio OUT cable can be connected. Connect to the line level input of an audio amplifier.
Plug the DC 12V power source provided into the power socket.
10/100Mbps Ethernet. There are two LEDs on the Ethernet connector
network connection is active. The amber LED flickers when
pin D-Sub is for attaching RS-232 control devices.
or external control via connected RS-485 keyboards and
Monitor output.
port is for feeding the Main Monitor video Out signal to a VGA monitor (Main Monitor).
equipment like monitors to the Video OUT connectors (bottom layer)
connecting an external SATA HDD bay.
Audio IN cables. Connect the line level output of an audio preamplifier to th
t. There are two LEDs on the Ethernet connector. When the
flickers when data is being exchanged.
ards and for on-screen-display control of
ptions are COM, N.C, and N.O types of
the Video IN connectors (top layer). You
connectors (bottom layer).
line level output of an audio preamplifier to the audio
Connect to the line level input of an audio amplifier.
6
This is done via the rear panel.
C monitor.
a VGA monitor (Main Monitor).