EverFocus PARAGON 264x1 User Manual page 49

Power Loss:
Log: This box should be permanently checked to log all
Power Loss incidents.
Email Notify: Check this box to enable email notification
of this event when power has been restored. This
requires that valid email settings have been entered in
the Network Setting > Email setup screen.
Network Alarm: Check this box to send out a network
alarm to a client PC when power has been restored.
(This feature requires PowerCon software on the client
PC and proper settings for the Alarm Server in the Network Setup menu; see the Alarm Server section for more information.)
NOTE: As alarms and emails cannot be transmitted without power, the log entry is made when power is restored, and the
same applies to all event notifications.
Network Loss:
Log: Check this box to record Network Loss events in the
log.
Buzzer: Check this box to activate the buzzer when the
network connection is lost.
Alarm Output: Click on one of the numbers in the
dropdown box to let the DVR transmit a signal through the
alarm output with the same number, if this event occurs.
Selecting "None" would disable this reaction.
Output Type: If an Alarm Output has been selected
above this setting, this setting will decide how that Output
is transmitted when this event occurs.
Timeout: The alarm output will last for a set period of
time. If this option is selected, a field will appear under this field for setting the period duration. Setting options are
1~150 seconds.
Permanent: The alarm will remain on until the user presses the "Enter" key on the front panel, or resets the alarm
configuration.
Transparent: The alarm output will continue for as long as the event trigger is detected.
Trans+Timeout: The alarm output will continue as long as the event trigger is detected, then it will continue for the set
time period.
Timeout Duration: This period refers to the Timeout output type above and can be from 1 to 150 seconds.
NOTE: This function only checks the physical connection (link) to the network. Any network behavior that blocks data
connectivity (blocked ports, IP addressing errors, etc.) is not detected by this function.
42