Ptz Express Control - EverFocus PARAGON 264x1 User Manual

a. Click the "Auto Pan" button
10. For Pattern (Pattern is the "0" Tour in Everfocus and Pelco PTZ cameras)
a. Click the "Pattern" button
b. If more than one pattern has been programmed, click the number of the desired pattern
c. Click the "Go" button
11. To run a Tour
a. Click the "Tour" button
b. Click the number of the desired tour
c. Click the "Go" button
12. To remove a Tour (if supported by the camera)
a. Click the "Tour" button
b. Click the number of the desired tour
c. Click the "Delete" button
Click "C" to clear the digit in the number display
Click "X" at the top-right corner to hide the PTZ menu (see Express control below)
Click "Exit" to leave the PTZ Control bar.
REMEMBER: "X" only HIDES the PTZ control panel. "EXIT" closes the panel and exits PTZ mode! Other controls will
not respond until you EXIT the PTZ mode!
4.2.2

PTZ Express Control

If the PTZ Control Bar has first been opened and then HIDDEN, the mouse can be used to control basic PTZ functions
(Quick Mouse Control). The mouse cursor will change to different icons when held in different areas of the screen (the areas
are shown in the image below). Simply click to activate the function represented by the mouse cursor-icon. With Quick
Mouse Control, the user can control PTZ direction, zoom, and focus by clicking directly on the screen. The screen is divided
into 16 areas, with the 12 outside blocks representing the direction controls. The 4 inside blocks represent the zoom and
focus controls. Right-click to display the PTZ Control Bar again.
Right: The PTZ Express Control areas:
The screen is divided into a 4x4 grid. The function
of each section is defined as below:
• 1: PTZ pan/tilt left and up
• 2, 3: PTZ tilt up
• 4: PTZ pan/tilt right and up
• 5, 9: PTZ pan left
• 8,12: PTZ pan right
• 13: PTZ pan/tilt left and down
• 14, 15: PTZ tilt down
• 16: PTZ pan/tilt right and down
• 6: Focus close
• 10: Focus far
• 7: Zoom in
• 11: Zoom out
REMEMBER: Clicking "X" at the top-right corner of the PTZ Control Bar only hides the PTZ menu. You have to click
"Exit" if you want to leave the PTZ function and enable the normal controls.
21