Battery Removal; Service And Warranty - Remington PRO POWER HC5350 User Manual

ENG SH LI

BATTERY REMOVAL

The battery must be removed from the appliance before it is scrapped.
The appliance must be disconnected from the supply mains when removing the battery.
Ensure the clipper is discharged of all power and disconnected from the mains.
Lift or pry the USB port cover plate on the bottom of the clipper.
Lift or pry the deco plate on the lower portion of the clipper and unscrew 1 screw located
on the back housing of the clipper.
Lift or pry the clipper halves apart, exposing the battery chamber.
Lift or pry the USB connector and lift or pry the cover plate on the bottom of the battery chamber.
Take out the battery and printed circuit board assembly from the battery chamber.
Cut the tabs on both ends of the battery and remove it from the printed circuit board
The battery is to be disposed of safety.
SERVICE & WARRANTY
This product has been checked and is free of defects. We warrant this product against any
defects that are due to faulty material or workmanship for a
date of consumer purchase. If the product should become defective within the warranty
period, we will repair any such defect or elect to replace the product or any part of it
without charge provided there is proof of purchase. This does not mean an extension of the
warranty period.
In the case of a warranty simply call the Remington
This warranty is offered over and above your normal statutory rights.
The warranty shall apply in all countries in which our product was sold via an authorised
dealer.
This warranty does not include cutters which are consumable parts. Also not covered is
damage to the product by accident or misuse, abuse, alteration to the product or use incon-
sistent with the technical and/or safety instructions required. This warranty shall not apply if
the product has been dismantled or repaired by a person not authorised by us.
3 year period from the original
Service Center in your region.
®
7