Table of Contents
Advertisement
ENGLISH
STEP 3 – SIDE OF THE HEAD
•
With the comb set at 3mm or 6mm, trim sideburns. Then change to the longer 9mm guide comb and
continue to cut the top of the head.
STEP 4 – TOP OF THE HEAD
•
Use the longer length comb attachment and set it to 12mm or 15mm then cut hair on top of the head
against the direction in which the hair normally grows.
STEP 5 – THE FINISHING TOUCHES
•
Use the clipper without an attachment comb for close trimming around the base and sides of the neck
and around the ears.
•
To produce a clean straight line at the sideburns, reverse the hair clipper. Place the reversed clipper at
right angles to the head, tips of the blades lightly touching the skin and then work downwards.
TURBO MODE
•
To run in Turbo mode, slide the on/off switch to the turbo position.
CARE FOR YOUR HAIRCLIPPER
•
To ensure long lasting performance of your clipper, clean the blades and unit regularly.
•
Always keep the clipper in the provided travel pouch.
•
Ensure the appliance is switched off and unplugged from the mains before cleaning.
•
Do not use harsh or corrosive cleaners on the unit or blades.
•
Cleaning should be done with a soft brush.
•
After each use - brush the accumulated hair from the blades.
WASHABLE CLEANING
•
The QuickCut Clipper is fully washable for easy cleaning.
•
Ensure the appliance is switched off and unplugged from the mains.
•
For best results, keep trimmer running while running it under the tap. Allow water to run through the
washout port and over the blades. Recommended to rinse after each use.
•
Ensure the clipper is dry after cleaning.
•
For more thorough cleaning the blade set can be easily removed to wash any hair trimmings from the
blades. To release the blade set, push the blade set release button found on the base of the clipper.
•
Ensure the blades are dry after rinsing under the tap. To reattach, align the blade set onto the clipper
and push the blade set towards the clipper body until it clicks into place.
•
Place a small drop of cutter or sewing machine oil onto the blades at each end and at the middle point
of the blades. Turn the unit on for a few seconds to distribute the oil then turn off and wipe off excess
oil.
BATTERY REMOVAL
We strongly recommend that a professional removes the rechargeable battery. Parts of the shaver case,
and tools have sharp edges and may cause injury if not handled correctly.
•
The rechargeable battery must be removed from the appliance before it is scrapped.
•
Disconnect the charging adapter before removing the battery.
1.
Turn the trimmer on and discharge all remaining power.
2.
Starting at the seam on either side of the top panel, pry open the seam working back and forth from
one side to the other, following the seam until the top panel has been pried apart all the way from the
rest of the clipper.
6
Advertisement
Table of Contents
