Table of Contents
Advertisement
•
Ensure the blades are dry after rinsing under the tap. To reattach,
align the blade set onto the clipper and push the blade set towards the
clipper body until it clicks into place.
•
Place a small drop of cutter or sewing machine oil onto the blades at
each end and at the middle point of the blades. Turn the unit on for
a few seconds to distribute the oil then turn off and wipe off excess oil.
NOTE: Keep the blades lubricated after contact with water.
WARNING: DETACH THE HAND-HELD PART FROM THE
SUPPLY CORD BEFORE CLEANING IT IN WATER.
BATTERY REMOVAL
We strongly recommend that a professional removes the rechargeable
battery. Parts of the shaver case, and tools have sharp edges and may
cause injury if not handled correctly.
•
The rechargeable battery must be removed from the appliance before
it is scrapped.
•
Disconnect the charging adapter before removing the battery.
1.
To do this, operate the device until it stops.
2.
Remove the blade set.
3.
Pry the top panel apart following the seam on either side.
4.
Remove the 6 screws from the housing.
5.
Remove the top and bottom housing.
6.
Pry the inner housing apart and remove the inner housing.
7.
Take out circuit board and battery
8.
Cut the battery connector.
•
The battery is to be disposed of safely.
Legislation in some localities mandates that e-waste (anything with a plug,
battery or cord) is disposed of through controlled recycling facilities and
must not be disposed of in general household waste. For more information
about recycling of electrical and battery operated appliances, please
contact your local council or your local household waste disposal service.
11
Advertisement
Table of Contents
