Every Six Months; Battery Removal - Remington HC5150 Instructions Manual

ENGLISH
• Note: Ensure the clipper is turned off when cleaning.

, EVERY SIX MONTHS

• At regular intervals the blade set should be removed and cleaned.
• Remove the 2 screws retaining the fixed blade with a screwdriver. Do not
remove blade set.
• Brush out hairs from between the blades with soft cleaning brush. Do not
remove the lubricating grease from the blades. It is not necessary to remove
the small moving blade from the unit.
• If the moving blade has been removed this can be re-fitted by slotting the
blade holder over the pin in the centre of the interior product head. The
groove on the blade, just below the teeth, rests on a metal plate at the
opposite side to the screw holes. The fixed blade is fitted with the raised
profile pointing outwards and fixed with the 2 screws.
• If the blades are not correctly aligned, cutting efficiency will be impaired.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe off
excess oil.
• Do not use liquid cleaners on the blades or harsh or corrosive chemicals on
the blade casing. Always use a soft brush to remove the accumulated hairs.
• Unplug the charge adaptor from the power outlet when fitting or removing
attachments, or while cleaning the product.
• Always store this appliance and cord in a moisture-free area.
• Do not wrap the cord of the charging adaptor around the appliance.

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing
the battery.
• Ensure that the clipper is discharged of all power and disconnected from the
mains
• Lift or pry the USB port cover plate on the bottom of the clipper.
• Lift or pry the deco plate on the lower portion of the clipper and unscrew 1
screw located on the back housing of the clipper.
• Lift or pry the clipper halves apart, exposing the battery chamber.
• Remove the battery and printed circuit board assembly from the battery
chamber.
• Cut the tabs on both ends of the battery and remove it from the printed
circuit board.
• The battery is to be disposed of safely.
7