Diagnostic Mode - Led Model; Fault Codes - Fisher & Paykel AQUASMART WL37T26CW2 Service Manual

478182
7 DIAGNOSTIC MODE – LED MODEL
This washer has a diagnostic system to help diagnose faults. Use Diagnostic Mode 2 for non-
dispensing LED models. For all other models use Diagnostic Mode 1.
To enter DIAGNOSTIC MODE 1 for dispensing models;
•
Turn the power on at the power point and off at the console.
•
Press and hold the HI-EFFICIENCY button, then press the POWER button until you here
two beeps.
To enter DIAGNOSTIC MODE 2 for non dispensing models;
•
Turn the power on at the power point and off at the console.
•
Press and hold the EASYIRON button, then press the POWER button until you here two
beeps.
7.1

Fault Codes

Enter diagnostics then press the SPIN button three times, until both the SLOW and HOLD lights
are on. The last fault code is now displayed in the wash cycle LEDs using a binary code. Each
LED has a value as follows:
LED
Regular
Heavy
Delicate
Sheets
Colours
Bulky
Easy Iron
Hi Efficiency =
The fault code is determined by adding up the value of the illuminated LEDs.
For Example:
128 64 32
This is Fault Code 24 – Dispensing type not set.
VALUE
= 128
= 64
= 32
= 16
= 8
= 4
= 2
1
16 8 4 2 1
38