Size Setting Mode; Diagnostic Mode; Last Fault Data; Drain Pump Test - Fisher & Paykel SMARTDRIVE PHASE 7 Service Manual

517790D
3

SIZE SETTING MODE

To set the size switch, turn the power on at the power point and off at the console. Press and hold
WASH TEMPERATURE SETTING UP then press POWER. SmartDrive
and the pattern of LEDs will change.
One of the following buttons needs to be pushed to lock the size into memory.
•
Press WASH TEMPERATURE SETTING UP, the COLD LED is on for 5.5kg (560mm wide).
•
Press WATER LEVEL UP, the LOW WATER LED is on for 6.5kg / 7.0kg (600mm wide).
•
Press SPIN SPEED UP, the SPIN HOLD LED is on for 7.5 / 8.0kg (650mm wide).
•
Press POWER to confirm the setting and also exit this mode.
If the size setting is wrong, SmartDrive
•
The Auto Water Levels chosen may be incorrect.
•
The High Water Level may be incorrect by as much as 40mm.
•
The wash profiles may be incorrect resulting in poor wash performance or vigorous wash
actions causing tangling, splash over or excess linting.
•
Water saver settings.
4

DIAGNOSTIC MODE

To enter diagnostic mode follow the steps below.
1. Turn the power on at the power point but off at the machine.
2. Press and hold WASH TEMPERATURE SETTING DOWN and then press POWER until the
machine gives 2 short beeps and lights up.
3. Release the buttons after the beeps as the beeps indicate diagnostic mode has been entered.
4.1

Last Fault Data

When in diagnostic mode the last fault can be found by pressing the SPIN SPEED UP or DOWN
buttons until the HOLD and SLOW lights are illuminated. Binary can then be read from the wash
progress lights.
4.2

Drain Pump Test

MW Washer
When in diagnostic mode press SMART TOUCH CYCLES to activate the drain pump.
deactivate the pump, press SMART TOUCH CYCLES again.
GW Washer
When in diagnostic mode press REGULAR to activate the drain pump. To deactivate the pump,
press REGULAR again.
®
will have the following settings incorrect: -
128 64 32 16 8
24
®
will give 4 short beeps
4 2 1
To