Restart/Recycle Features Permanently Programmed; Data Download - Fisher & Paykel AQUASMART WL37T26CW2 Service Manual

478182
6.2.5

Restart/Recycle Features Permanently Programmed

It is possible for the Restart Feature to be disabled, or the Recycle Feature to be enabled, or a
combination of both to be permanently programmed into the memory of the electronics so that in
the event of a power cut the electronics will remember the setting.
The factory settings are:
•
Restart is enabled
•
Recycle is disabled
If a machine is encountered with the Restart/Recycle features not set to the factory defaults, the
machine must be re-programmed using following steps;
1. Enter diagnostic mode by pressing and holding the HI-EFFICIENCY button and then
pressing the SELECT button. Keep the buttons pressed for at least 2 seconds, after which
time two beeps will be heard and a screen showing 'Service' & 'Control' will appear.
2. Using the arrow buttons, highlight the 'Control' screen, then press SELECT.
3. To enable/disable the Restart feature permanently, press and hold the LEFT SCROLL
ARROW for three seconds until a beep is heard.
4. To enable/disable the Recycle feature permanently, press and hold the RIGHT SCROLL
ARROW for three seconds until a beep is heard.
6.3

Data Download

To activate the data download, enter the diagnostic mode with the power on at the power point and
off at the console, press and hold the HI-EFFICIENCY and SELECT buttons. Keep the buttons
pressed for at least 2 seconds, after which time two beeps will sound. Then press the
START/PAUSE button. The LED above the High Efficiency button will be on and flickering.
Place the download pen over this LED and follow the instructions supplied with the data download
program.
LED for data download
36