Table of Contents
Advertisement
517766
16. DIAGNOSTIC MODE
16.1
GW (Ecosmart)
Turn the power on at the power point but off at the machine. Press and hold the WASH
TEMP DOWN button and then the POWER button until the machine gives 2 short beeps
and lights up.
Release buttons when the beeps indicate diagnostic mode has been
entered.
Note: The power button is relocated to the left of the panel but central to the console, not
on the right hand side as with all previous GW Smart Drive machines.
Last fault can be found by pressing the SPIN SPEED UP button three times. The HOLD
and SLOW lights should be illuminated. Binary can then be read from the wash progress
lights. Fault code 49 is shown above, 32+ 16+ 1 = 49
Binary code is read from the Wash Progress lights.
128
64
o
o
32
16
8
o
o
o
which is a cold water valve fault.
4
2
1
o
o
o
- 14 -
March 2003
Hide quick links:
Advertisement
Table of Contents
